Sega The Maze of the Kings - Wiring Connections

17
3.7.3.1.WIRING CONNECTIONS.
COIN MECH LOOM INSTALLATION
C220B LM1006IDC
LM1006LAMP-0.1
· Attach the lamp holder to the bracket on the coin return
button.
· Attach one 15-way connector to the C220 coin mech.
· Attach the other 15-way connector to Validator A on the
credit board.
· Attach the 2-way connector to ‘LAMP’ on the VTS board.
GENERIC
MECHANICALS
LM1008
LM1008-LAMP
· Fit the two lamp holders behind the coin return buttons.
· Attach the blue cable and orange cable to one mech’s
micro-switch switch.
· Attach the blue/green cable and orange/green cable to
the other mech’s micro-switch.
· Attach the 2-way mate and lok plug to the 2-way mate
and lok cap provided.
· Attach one 15-way connector to Validator A and the
other to Validator B on the credit board
MARS MS111B1
MARS ME115
LM1007
LM1008-LAMP
· Fit the lamp holder to the bracket behind the coin return
button.
· Fit one of the 13-way connectors to the coin mech.
· Fit the other 13-way connector to Validator A on the
credit board. Note the 13-way connector is keyed and
this key must coincide with the key on the credit board.
SECI, C120,
SR3
OWN LOOM AND
LM1006LAMP-0.1
· Attach the lamp holder to the bracket on the coin return
button.
· Attach the 2- connector to ‘LAMP’ on the VTS board.
· Attach the validator’s own loom to position A on the
credit board
VTS credit board assembly