23
3.10. REPLACEMENT OF FLUORESCENT LAMP AND OTHER LAMPS
· Never touch places other than those specified. Touching places other than those
specified can cause electric shock and short circuit. Disconnect the machine from
the supply before attempting the replacement of any lamp.
· Use a step to perform work on the Billboard. Ensure the step is secure to avoid
injury.
· The Fluorescent Lamp can get hot and cause burns. Allow the Lamp to cool
before touching it.
· Only QUALIFIED SERVICE PERSONNEL should replace lamps.
3.10.1.FLUORESCENT LAMP REPLACEMENT
1. Remove Pop Panel (if fitted) and associated bracket by removing 3 x M4 Truss Screws.
2. Remove the M4 Truss Screws to remove the Sash. Withdraw the Billboard Plate upwards.
3. To remove the Fluorescent Lamp, first remove both end connectors. Then withdraw the Lamp from the
two clips, using care to avoid breakage.
4. Replacement of Lamp is in reverse order of removal.
To Next Page
Loading...
