2-5
Highlight Switch
“
” Lamps off
.
“
” Position light
.
“
” lamps on
.
High Beam Switch
The ignition switch must be in the on position to operate the headlights. Press
the switch to this position and place the headlight on the high beam. At this
point, the corresponding figure on the meter will be bright.
Press the switch to this position and place the headlight on the low beam.
Turn Signal Switch (if equipped)
Press the switch to this position and the left turn signal is on. The
corresponding icon on the meter is lit at this time.
Press the switch to this position and the right turn signal is on. The
corresponding icon on the meter is lit at this time.
Turn off the turn signal in the middle.
Emergency Sight Switch(if equipped)
“ ”
：
Emergency light on
.
“
”
：
Emergency light off
.
Use this switch in case of vehicle emergency
• Temporary stop of vehicle
• Vehicle failure
• The vehicle encountered other emergencies
Switchs 2
1
Horn Switch
2
Mode Switch
Horn Switch
“ ” horn on
.
Mode Switch
“ S ” Sports model
“ E ” Economic model
(
6
To Next Page
Loading...
