4-22
SHOCK ABOSRBER
Shock abosrber preload adjustment
The spring adjusting nut of the air pressure damping shock absorber is at the
upper end of the spring. Use a crescent wrench to loosen the lock nut. Then turn
the adjusting nut to loosen.
Adjust the nut position according to the range of the table below to achieve the
required comfort
1
Locknut
2
Adjusting Nut
3
Crescent wrench
A
Spring preload position
Screw the locknut to the desired position, then unscrew the adjusting nut to adjust
the position of the nut
.
Setting standard of spring preload position:
Item Factory setting Available range
Front shock absorber:
Air pressure adjustable damping
spring preload setting position
(From the bottom of the upper
mounting seat to the position of
the adjusting nut)
64" Narrow version
35mm(1.4in.)
20
～
45mm(0.8
～
1.8in.)
72" Wide version
85mm(3.34in.)
65
～
95mm(2.6
～
3.74in.)
Rear shock absorber:
Air pressure adjustable damping
spring preload setting position
(From the bottom of the upper
mounting seat to the position of
the adjusting nut)
64" Narrow version
35 130mm(5.1in.)
120
～
150mm(4.73
～
5.9in.)
72" Wide version
170mm(6.7in.)
170
～
210mm(6.7
～
8.37in.)
High-speed compression
damping adjustment (clockwise
adjustment)
Third Level 1-9 Level
Low speed compression
damping adjustment (clockwise
adjustment)
First circle 0-2.5 circle
Restoration damping adjustment
(adjusted from clockwise)
First Level 1-14 Level
Gas pressure 1Mpa
Gear Spring Environment Load Terrain
Speed
1
Soft
↑
↓
Hard
Flexible
↑
↓
Solid
Light
↑
↓
Heavy
Flat
↑
↓
Bump
Low
↑
↓
High
2
3
4
5
To Next Page
Loading...
