SEH EPS TSE Server 8 - Page 17

15 [en] Manual
Changing the Administrator Password
1. Start the EPS TSE Server Control Center.
2. Select SETTINGS – Users.
3. In the Users table, click the pencil icon for the admin user.
The Change Password dialog appears.
4. Enter the new password in the Password field of the Create Local User dia-
log.
5. Enter the new password again in the Retype field of the Create Local User
dialog.
6. Click Save to confirm.
 The password has been changed.
Creating a Local User
1. Start the EPS TSE Server Control Center.
2. Select SETTINGS – Users.
3. Enter the user name in the Name field of the Create Local User dialog.
4. Enter the password in the Password field of the Create Local User dialog.
5. Enter the password again in the Retype field of the Create Local User dialog.
6. Click Save to confirm.
 The user has been created.
Deleting a Local User
1. Start the EPS TSE Server Control Center.
Description
[sys_descr]
max. 64 characters
[a–z, A–Z, 0–9] and
[._-@&:?!"]
Device description, e.g. location
or department.
Password (802.1X
authentication)
min. 8 characters
max. 64 characters
[all ASCII] except 0x0-
0x1f, 0x7f-0xff
Defines the password for an
802.1X authentication method
Important:
Observe the value conventions during input
14!
Important:
Observe the value conventions during input
14!
Entry Value Description