19
Push firmly the part indicated by the arrow in Figure 8-7 and Figure 8-8 to close the paper cover to (5)
avoid one side lock defect.
After closing the paper cover, paper feed and paper cutting are performed automatically.
Top eject Front eject
Figure 8-7 Paper Cover (Top Eject) Figure 8-8 Paper Cover (Front Eject)
NOTE
◆
Pull the thermal paper straight.
◆
Push the paper cover firmly to close and avoid one side lock defect.
◆
Be sure to operate the release lever to the end. If not, the paper cover may not open.
◆
DO NOT cover the paper outlet or hold down the thermal paper ejected. Doing so may
cause a paper jam.
◆
DO NOT touch the gear of the platen and/or the gear of the printer. Doing so may
cause loss of printing quality or damage.
HINT
•
Leaving the printer with the thermal paper for a long time may cause a paper feeding
problem because the surface of the thermal paper sticks to the thermal head due to the
environmental changes. In that case, open the paper cover to separate the thermal paper
from the thermal head, and then close the paper cover before use.
To Next Page
Loading...
Need help?
General
