27
A message for selecting the function assigned to the selected MS is printed as a sample shown in (5)
Figure 11-3.
Press the FEED Switch the number of times corresponding to the selected function number, and
then press the POWER Switch.
・When pressing the FEED Switch once, "1 : Standby LED" is selected.
・When pressing the POWER Switch without pressing the FEED Switch, "0 : Return to MS Selection" is
selected.
Figure 11-3 Function Selection Message
(Example: Selected MS1)
A message for selecting the setting value of the selected function is printed as a sample shown in (6)
Figure 11-4.
Press the FEED Switch the number of times corresponding to the selected setting value number,
and then press the POWER Switch.
・When pressing the FEED Switch once, "2 : Green" is selected.
Figure 11-4 Setting Value Selection Message
(Example: Selected Standby LED)
A message for confirming the selected setting value is printed as a sample shown in Figure 11-5. (7)
Figure 11-5 Setting Value Confirmation Message
(Example: Selected Green)
Press the FEED Switch to save the setting value to the memory. Figure 11-2 is printed.
Press the POWER Switch to discard the selected item. A message of the function selection is
printed as a sample shown in Figure 11-3. If select "0 : Return to MS Selection" there, function
selection is not performed, and Figure 11-2 is printed.
To continue to set functions, return to (4).
To exit the Setting Mode, select "0 : Exit" in Figure 11-2. (8)
The test print and Figure 11-1 printing start again. Verify that the functions are properly set.
[Function selection of MS1]
0 : Return to MS selection
1 : Standby LED
2 : Auto Activation by AC
3 : Power SW
Press the FEED switch an equal
number of times to the selected number.
After that, press the POWER SW.
[Standby LED]
0 : Return to function selection
1 : Aqua
2 : Green
3 : Off
4 : Blue
Press the FEED switch an equal
number of times to the selected number.
After that, press the POWER SW.
[Standby LED]
Set Green
Save setting : Feed SW
Discard setting : Power SW
To Next Page
Loading...
Need help?
General
