Seli STS-03 - Calibration Using Reference Device

18 Troubleshooting
73
18.6 Error message on the display
 error message
 remedy
 Err0
Factory comparison failed
 Repair with the manufacturer
 Err1
User parameters incorrect
 Use the RST function in order to
reset the user parameters (chapter
5.7)
 Err2
Temperature measurement failed
 Repair with the manufacturer
 Err3
Measuring range spreading failed
 Check the parameters “MRB” and
“MRE”. Maximum spreading 4:1
 Err4
ADC error
Repair with the manufacturer
 Err4
Temperature overriding (100°C)
Factory setting
Lower the temperature of the medium
below 100 ° C again