SemaConnect 6 Series - Dedicated Power

To Next Page

To Previous Page

1.4.2. Dedicated Power

All wiring used in the installation must meet NEC guidelines for supplying 30A

continuously.

1. Each EV charging station shall be on a dedicated electrical circuit.

2. Each station shall be protected with a 40 Amp 2-pole common trip circuit breaker (non-GFCI type).

3. Each station is designed to draw a maximum of 30Amps.

4. Each station can operate on either a 240V or 208V circuit. Wire size should meet NEC guidelines for

40A circuit breaker supplying 30A current.

5. Each station requires three electrical supply wires (two hot, one ground, no neutral).

6. All data communication is wireless, so no data cabling needed, but cellular communication is required.

Station Wiring Diagram – Dedicated Power

Installation Manuals Series 6 EV Charging Station - 1

Other manuals for SemaConnect 6 Series