SemaConnect 6 Series - Safety and Compliance

To Next Page

To Previous Page

1.1. Safety and Compliance

This document provides instructions to install the SemaConnect Charging station and should not be used for

any other product. This product must be installed in accordance with the National Electrical Code (NEC) or

the Canadian Electrical Code (CEC) whichever is applicable. Consult a licensed contractor and/or

electrician before installation to ensure compliance with local building practices, climate conditions, safety

standards, and state and local codes. Under no circumstances will compliance with the information in this

guide relieve the installer of responsibility to comply with all applicable codes and safety standards.

This document describes the most common installation and mounting methods. Contact SemaConnect

where it is not possible to perform an installation using the procedures provided in this document.

SemaConnect is not responsible for damages that may occur during or as a result of installation.

In no event shall SemaConnect, Inc. Or its authorized distributors be liable for any indirect, incidental,

special, punitive, or consequential damages, including without limitation, lost profits, lost data, loss of use,

cost of cover, or loss or damage to the SemaConnect charging station arising out of or relating to the use or

inability to use this guide, even if SemaConnect, Inc. Or its authorized distributors have been advised of the

possibility of such damages.

SemaConnect Charging station is a trademark of SemaConnect, Inc. All other products or services

mentioned are the trademarks, service marks, registered trademarks or registered service marks of their

respective owners.

The copyright laws of the United States and other countries protect this material. It may not be modified,

reproduced or distributed without the prior, express written consent of SemaConnect, Inc.

This guide assumes that the appropriate wiring, conduit and circuit protection is in place at the installation

site. Review this entire document to understand the installation process before installing the SemaConnect

Charging station.

Installation Manuals Series 6 EV Charging Station - 1

Other manuals for SemaConnect 6 Series