3S PLUS
11
English
3.5 Checking the Battery Level
When the headset is powering on, the red LED ashes rapidly
indicating the battery level.
4 ashes = High, 70 ~ 100%
3 ashes = Medium, 30 ~ 70%
2 ashes = Low, 0 ~ 30%
3.6 Volume Adjustment
You can raise or lower the volume by tapping the (+) Button or the
(-) Button. Volume is set and maintained independently at different
levels for each audio source, even when the headset is rebooted.
4 PAIRING THE HEADSET WITH OTHER
BLUETOOTH DEVICES
When using the headset with other Bluetooth devices for the rst time,
they will need to be “paired.” This enables them to recognize and
communicate with one another whenever they are within range. The
headset can pair with multiple Bluetooth devices such as a mobile
phone, GPS, MP3 player or Sena SR10 Two-Way Radio Adapter via
Mobile Phone Pairing, Second Mobile Phone Pairing and GPS
Pairing.
4.1 Phone Pairing
There are three ways to pair the phone.
4.1.1 Initially Pairing the headset
The headset will automatically enter the phone pairing mode when you
initially turn on the headset or in the following situations:
• Rebooting after executing Factory Reset; or
• Rebooting after executing Delete All Pairings.
1. Press and hold the (+) Button and (-) Button for 1 second.
2. You will hear a voice prompt, “Phone pairing”.
To Next Page
Loading...
