Sena 3S PLUS - Delete All Pairings; Factory Reset; Software Configuration Setting; Unit Language

3S PLUS
17
English
10.1.1 Delete All Pairings
You can delete all Bluetooth pairing information of the headset.
10.1.2 Factory Reset
You can restore factory default settings on the headset.
10.2 Software Conguration Setting
You can change the settings of the headset through the Sena Device
Manager or the Sena Utility App.
10.2.1 Unit Language
You can select the device language. The selected language is
maintained even when the headset is rebooted.
10.2.2 VOX Phone (Default: Enable)
If this feature is enabled, you can answer incoming calls by voice.
When you hear a ringtone for an incoming call, you can answer the
phone by saying a word such as “Hello” loudly or by blowing air into
the microphone. VOX phone is temporarily disabled if you are
connected to intercom. If this feature is disabled, you have to tap the
(+) Button to answer an incoming call.
10.2.3 HD Intercom (Default: Enable)
HD Intercom enhances the two-way intercom audio from normal
quality to HD quality. If this feature is disabled, the two-way intercom
audio will change to normal quality.
Note: The intercom distance of HD Intercom is relatively shorter than that of
normal intercom.
10.2.4 HD Voice (Default: Enable)
HD Voice allows you to communicate in high-denition during phone
calls. This feature increases the quality so that the audio will be crisp
and clear during phone call conversations. If this feature is enabled,
incoming phone calls will interrupt intercom conversations and audio
from the SR10 will not be heard during intercom conversations.
Note: Refer to the manufacturer of your Bluetooth device that will be connected
to the headset to see if it supports HD Voice.