Sena SP38 - Ambient Mode; Voice Command Control

20S
32
Mode Status Function Voice Command
Standby / Music /
FM Radio /
Start/End each Intercom
“Intercom
[one, two, … , nine]”
End all intercoms
“End intercom”
Call last intercom
“Last intercom”
Group Intercom
“Group intercom”
Intercom pairing
“Pairing intercom”
Cancelling operations
“Cancel”
Standby
Play/Pause music
“Music” or “Stereo”
Turn on/off FM radio
“FM radio”
Check battery
“Check battery”
Speed dialing
“Speed dial
[one, two, three]”
Redial the last call
“Redial”
Voice command help
“What can I say?”
Check connected devices
“Connected
devices”
Conguration menus
“Conguration”
Mode Status Function Voice Command
Music / FM Radio
Next track (music) / next
preset (FM radio)
“Next”
Previous track (music) /
previous preset (FM radio)
“Previous”
Stop music / FM Radio
“Stop”
Note:
1. Voice command performance may vary based on the environmental
conditions including riding speed, helmet type and ambient noise. To
improve the performance, minimize wind noise on the microphone by
using the large microphone sponge and closing the visor.
2. To activate the voice command during non-stand-by functions, tap the
Ambient Mode Button or double tap the surface of the main unit.
3. If the 20S is in stand-by mode for longer than one minute then the
microphone will automatically be disabled and the Voice Command
feature cannot be activated by saying “Hello Sena”. The Voice
Command feature will need to be activated by tapping the Ambient
Mode Button once or double tapping the surface on the 20S.