48
21.6 Setting Smart Volume Control
Voice Prompt
“Smart volume control”
Factory Default Disable
Level Adjustment
Rotate the Jog Dial
(Low/Medium/High/Disable)
Apply Tap the Jog Dial
Smart Volume Control automatically changes the level of the speaker
volume based on the level of the environmental noise. When it is
disabled, volume is controlled manually. Rotate the Jog Dial until you
hear the voice prompt, “Smart volume control”. By tapping the Phone
Button, it will lead you to the level adjustment mode. You can enable
it by setting the sensitivity to low, medium, or high. Smart Volume
Control responds to smaller environmental noises as the sensitivity
level becomes higher.
21.7 Setting Motion Sensor Sensitivity
Voice Prompt
“Motion sensor sensitivity”
Factory Default Low
Level Adjustment
Rotate the Jog Dial
(High/Low/Disable)
Apply Tap the Phone Button
Motion Sensor Sensitivity determines the sensitivity when you double
tap on the surface of the 20S to enter voice command mode. Rotate the
Jog Dial until you hear the voice prompt, “Motion sensor sensitivity”.
By tapping the Phone Button, it will lead you to level adjustment mode.
Default is at low, but you may change it to high, or disable the feature
by rotating the Jog Dial. After you have completed the setting, tap
the Phone Button to apply the changes. If this feature does not work
properly, disable this feature, and press on the Ambient Mode Button
to enter voice command mode.
To Next Page
Loading...
