SPH10
12
systems use mobile phone profile for turn-by-turn
voice instruction. You can simultaneously use a
mobile phone and a GPS which uses mobile phone
profile by one of the following procedures.
6.4.1 Multipoint GPS Pairing
If you use GPS only for turn-by-turn voice instructions,
not for Bluetooth stereo music streaming, multipoint
pairing is recommended for the GPS connection.
Multipoint Bluetooth pairing allows the SPH10 to
connect two HFP devices at the same time: mobile
phone and GPS navigation. Follow the steps below to
pair the GPS using the multipoint pairing.
1. Turn on the headset and press the Jog Dial for 5
seconds until the red LED is rapidly flashing and
you hear multiple beeps.
2. Within 2 seconds, tap the Phone Button again, then
the LED turns to blue flashing and the beeps turn
to high tone double beeps. You will hear a voice
prompt saying “Multipoint pairing”.
3. Search for Bluetooth devices on the GPS navigation
screen. Select the Sena SPH10 in the list of the
devices detected on the GPS.
4. Enter 0000 for the PIN.
5. The GPS confirms that pairing has completed and
the SPH10 is ready to use. You will hear a voice
prompt from the SPH10 saying “Your headset is
paired”.
6. If the pairing process is not completed within three
minutes, the SPH10 will return to stand-by mode.
The pairing diagram for multipoint GPS pairing is
shown in the figure below.
Multipoint GPS Pairing
Smart Phone
SPH10
GPS
HFP
+
A2DP
Mobile Phone
Pairing
Multipoint
Pairing
HFP
To Next Page
Loading...
Need help?
General
Weight and Dimensions
