37
SPH10
English
19. INTERCOM RECONNECTION
If your intercom friend goes out of range while having
an intercom conversation, you may hear static noise
and eventually the intercom will be disconnected. In
this case, the SPH10 automatically tries to reconnect
the intercom every 8 seconds and you will hear high
tone double beeps until the intercom is reestablished.
If you don’t want to make a reconnection, tap the Jog
Dial to stop the attempt.
20. RESET TO FACTORY DEFAULT
SETTINGS
1. To restore the SPH10 to factory default settings,
press and hold the Phone Button for 12 seconds
until the LED shows solid red and you hear double
beeps. You will hear a voice prompt saying
“Factory reset”.
2. Within 5 seconds, press the Jog Dial to confirm
reset. The headset will be restored to factory
setting and switched off automatically. You will
hear a voice prompt saying “Headset reset,
good-bye”.
3. If you don’t press the Jog Dial within 5 seconds,
the reset attempt is canceled and the headset
returns to stand-by mode. You will hear a voice
prompt saying saying “Canceled”.
To Next Page
Loading...
