Sena SPH10 - Mobile Phone Call Management; Making, Answering, and Transferring Calls

SPH10
24
12. MOBILE PHONE CALL MAKING AND
ANSWERING
12.1 Mobile Phone Call Making and Answering
1. When you have an incoming call, simply tap the
Phone Button or the Jog Dial to answer the call.
2. You can also answer the incoming call by loudly
speaking any word of your choice if Voice Activated
Phone Answering is enabled.
3. To end a call, tap the Phone Button or press the
Jog Dial for 2 seconds until you hear a beep, or
wait for the called person to end the call.
4. To reject a call, press the Jog Dial for 2 seconds
until you hear a beep while the phone is ringing.
5. To transfer a call between the mobile phone and
the headset during the phone conversation, press
the Phone Button for 2 seconds until you hear a
beep.
6. There are several ways to make a phone call:
- Enter numbers on your mobile phone keypad
and make a call. Then the call is automatically
transferred to the headset.
- For some older mobile phones which do not
automatically transfer calls to the headset, press
the Phone Button after entering phone numbers
on the mobile phone keypad.
- Tap the Phone Button in stand-by mode to activate
the voice dialing of your mobile phone. For this,
the voice dialing feature must be available on
the mobile phone. Refer to your mobile phone
manual for further instruction.
Note:
1. If you are using multipoint mobile phone connection
and you have an incoming call from the second
phone during the call of the first phone, then you may
still receive the call from second phone. In this case,
the call from the first phone is on waiting mode. If you
end a call, then it will automatically guide you to the
first phone call.
2. If you are using multipoint connection of mobile
phone and GPS, you may not be able to listen to the
GPS voice instruction during the phone call.