Step 2: Install handlebar on the stem
A. Place the handlebar on the stem correctly. Trace the front brake cable directly
up from the front brake caliper to the left handlebar and ensure the cables and
wires are not twisted.
B. Locate the four handlebar faceplate bolts in the accessory box.
C. Center the handlebar and tighten the four stem faceplate bolts evenly and
part way.
D. Secure to the recommended torque value. Once adjusted properly, use a
torque wrench with a 5 mm Allen bit to evenly tighten the four stem
faceplate bolts (shown at right) to the recommended torque value, 10
Nm.
Get help from a bike fitting professional for safety and optimal fit and bike ergonomics.
Consult a certified, reputable, and local bike fitting specialist for assistance properly fitting
the bike to a rider.
To Next Page
Loading...