Pre-Ride Safety Checklist
Notice: Before every ride, and after every 25-45 miles (40-72 km), we advise following the pre-ride safety checklist.
Ensure front and rear brakes work properly.
Check brake pads for wear and ensure they are not over worn.
Ensure brake pads are correctly positioned in relation to the rims.
Ensure brake cables are lubricated, correctly adjusted, and display no obvious wear.
Ensure brake levers are lubricated and tightly secured to the handlebar.
Test that the brake levers are firm and that the brake, motor cutoff functions, and the brake light are
functioning properly.
Ensure tires are inflated within the recommended limits posted on the tire sidewalls and hold air.
Ensure tires have good tread, have no bulges or excessive wear, and are free from any other damage.
Ensure rims run true and have no obvious wobbles, dents, or kinks.
Ensure all wheel spokes are tight and not broken.
Check axle nuts and front wheel skewer and nuts to ensure they are tight.
Ensure the handlebar and stem are correctly adjusted, tightened, and allow proper steering.
Ensure the handlebar is set correctly in relation to the forks and the direction of travel.
Ensure the chain is clean, oiled, and runs smoothly.
Extra care is required in wet, salty/otherwise corrosive, or dusty conditions.
Ensure all bearings are lubricated, run freely, and display no excess movement, grinding, or rattling.
Check headset, wheel bearings, pedal bearings, and bottom bracket bearings.
Ensure pedals are securely tightened to the cranks.
Ensure the cranks are securely tightened and are not bent.
7. Derailleur and
Mechanical
Cables
Check that the derailleur is adjusted and functioning properly.
Ensure shifter and brake levers are attached to the handlebar securely.
Ensure all shifter and brake cables are properly lubricated.
To Next Page
Loading...