Battery Charging
Charging Procedure
Follow these steps for charging your bike from Senada Bikes:
1. Ensure the battery is off by having the battery pack on the 0button
2. Remove the rubber cover on the charging port on the opposite side of the battery
from the key
3. Plug the charger into the battery’s charging port. With the battery on or off the bike,
place the charger in a flat, secure place, and connect the DC output plug from the charger
(round barrel connector) to the charging port on the side of the battery.
4. Plug the charger into a power outlet. Connect the charger input plug (110/220-volt plug) to the power outlet. Charging
should initiate and will be indicated by the LED charge status lights on the charger illuminating to redlight.
5. Unplug the charger from the outlet, then the charging port. Once fully charged, indicated by one charging indicator light
turning green (and one remaining red), unplug the charger from the wall outlet first and then remove the charger output
plug from the battery charging port.
Always charge your battery in temperatures between 50 °F – 77 °F (10 °C – 25 °C) and ensure the battery and charger are not damaged
before initiating charge. If you notice anything unusual while charging, please discontinue charging and use of the bike and contact
Senada Bikes Product Support for help.
*There is no on/off button on the battery for charging the bike.
To Next Page
Loading...