Step 6: Install the pedals. Locate the pedal with a smooth
pedal
axle exterior and an engraved “R”, which indicates it is the
ri
g
ht
p
edal
(as shown below). The right pedal goes on the crank on
the right side of the bike (which has the drive train
g
ears and is the
same as a rider’s right side when riding).
A
pp
l
y
a small amount of
grease to the thread of the pedal of each axle as shown below
The right pedal (1) is threaded so that it is tightened by turning clockwise. Carefully thread the right pedal onto the
crank on the right side of the bike slowly and by hand by rotating clockwise. Do not cross thread or damage the
threads and make sure to tighten the pedal with wrench provided
To Next Page
Loading...