Adjusting the Seat Position and Angle
To change the angle and horizontal position of the seat:
1) Use a 6 mm Allen wrench to loosen the seat adjustment bolt on the clamp positioned
immediately underneath the seat, above the rear wheel. Do not remove the boltfully.
2) Move the seat backward or forward and tilt to adjust the angle. A seat position
horizontal to flat ground is desirable for most riders. Do not exceed the limit markings
on the seat rail, which show the minimum and maximum horizontal movement allowed.
3) While holding the seat in the desired position, use a 6 mm Allen wrench to tighten
the seat angle adjustment bolt securely to the recommended torquevalue.
Prior to first use, be sure to tighten the seat clamp via the seat adjustment bolt properly. A
loose seat clamp or seatpost adjustment bolt can cause damage to the bike, property, loss of
control, a fall, serious injury, or death. Regularly check to make sure that the seat clamp is properly tightened.
To Next Page
Loading...