Senco SLS18BL - Page 7

7
Tool Loading Unloading Exhaust Trigger Type
Auto Fire Option
Depth of Drive Adjustment
Jam Clearing Safety element
SFT10XP
Bottom Load (A1)
Release at rear of tool (B1)
Rear
Single (D1)
(E1)
None Via magazine None
SFT10XP-LN SFT10XP-DL Release at magazine (B2) SFW09 Release at rear of tool (B1) Dual
SFW05 Release at magazine (B2) Single (D1) NA SKSXP
Top Load (A2) Pull feeder. Tap to release (B3)
Moveable
Bottom fire (I)
NA
None
Gate (F1) Yes
SNS41XP Adjustable (C1)
At safety footNS20XP
Front (E2)
NS20BXP PS15XP
At trigger well
PS20XP SQS55XP Adjustable (C1)
(E1)
At safety foot
SLS25XP
Top Load (A2) Pull feeder. Tap to release (B3)
Moveable
Sequential (D1) At linkage Gate (F1) YesSLS20XP
SMS92 Adjustable (C1) NA SLS18Mg
Bottom Load (A1) Release at rear of tool (B1)
Rear, Adjustable (C2) Selectable
NA
At trigger well
Via magazine Yes
S150LS
Adjustable (C1) Single (D1) At linkageS150MS
SLS18BL WC330
Top Load (A2) Pull feeder. Tap to release (B3) Front Single (D1) NA At linkage Via magazine Yes
WC360
Matrix Picture no.
Description Image Notes
A1
Bottom Load
Do not load with trigger depressed
A2
Top Load
Do not load with workpiece contact (safety element) or trigger depressed
B1
Release at rear of tool
Depress latch, Slide rail open
B2
Release at magazine
Depress latch, Slide rail open
B3
Pull feeder. Tap to release
Pull feeder shoe back into “locked” postion.
C1
Adjustable
The deflector can be rotated to change the direction of the exhaust air
C2
Rear, Adjustable
The deflector can be rotated to change the direction of the exhaust air
1
2
Matrix Picture no.
Description Image Notes
D1
Single
①
Press the workpiece contact (safety
element) against the work surface. ②
Pull the trigger and the fastener is driven.
D2
Bottom
①
Pull trigger.
②
Depress workpiece contact element against
work surface and drive a fastener. Each time you push the workpiece contact (safety element) against the work surface, a fastener is driven.
E1
Auto Fire Option
These tools are equipped with a drive rate adjustment. To adjust the speed, rotate the screw not more than three turns, counterclockwise to increase the drive rate. Rotate the screw clockwise not more than three turns, to slow the drive rate. For single shot operation, pull trigger only partially. For automatic operation, pull trigger fully.
E2
Auto Fire Option
This tool is equipped with a drive rate adjustment. To adjust the speed, rotate the screw, not more than three turns, counterclockwise (Q) to increase the drive rate. Rotate the screw clockwise (P), not more than three turns, to slow the drive rate.
F1
Gate
Release E-Z Clear latch and open door.
2 1
EN