Sencore SMD 989 - SNMP Trap Managers

105 pages

Save Page as PDF

To Next Page

To Previous Page

SMD 989– User Manual

Page 63 (105)

SNMP Trap Managers

The managers for the SNMP management can be entered or removed by clicking on “Configure

SNMP Managers”

Figure 68: SNMP Managers

Main Page

Safety Precautions5
Introduction11
Abbreviations12
Hardware Overview13
Mhz Reference Input14
SMD 910 Option (Single or Multistream/If Output)15
SMD 920 Option (L-Band Output)16
SMD 940 Option (10Mhz Reference on L-Band)17
SMD 952 Option (Dual Redundant AC Power Supply)18
Software Licensing Overview19
SMD 965 Option (30 Msps)20
Installation21
Rack Installation22
Controlling the SMD 989 Using the Web GUI23
ASI Inputs24
Figure 18: ASI Configuration25
IP Inputs (SMD 910)26
Figure 20: Expanded IP Status27
Figure 22 IP Inputs on SMD91229
Figure 23 IP Input Settings on SMD 912(A) Modulator30
Figure 24 IP Input Details List with SMD 912(A)32
Modulator Settings33
Configure Modulator – Modulation34
Configure Modulator – Inputs35
Configure Modulator – Modulation Parameters36
Figure 31: Supported Modulations & Code Rates for DVB-S/DSNG and DVB-S237
Configure Modulator – Carrier ID39
Configure Modulator – TS Analysis41
Configure Modulator – S2 Multistream42
Configure Modulator - PRBS43
Configure Modulator - BISS44
Configure Modulator – Turbopsk45
Figure 39 Advanced Modulation Turbo PSK Modes and Code Rates46
Figure 40: Reduced Latency Selections47
Configure Modulator – DVB-S2X48
Output Settings52
IF Output53
Figure 45: RF Settings54
Admin Tab55
User Profiles56
Diagnostics57
Unit Software Rollback58
Unit License Update59
Figure 61: Network Configuration60
Figure 63: Configure Clone Settings61
SNMP Communities62
SNMP Trap Managers63
Alarms/Log Tab64
Alarms/Logs Configure65
Figure 75: Alarm Descriptions66
Figure 76: Event Configuration67
SNMP Trap Configurations68
Figure 80: SNMP Trap Descriptions69
About Tab70
Controlling the SMD 989 Using the Front Panel71
Front Panel Modulator Settings72
Modulator Configuration – Modulation Mode/Configuration73
Modulator Configuration – Modulator Parameters (Inputs)74
Modulator Configuration – Modulator Parameters76
Modulator Configuration- BISS Configuration78
Modulator Configuration- PRBS Configuration79
TS Analysis Configuration81
Output Configuration83
Front Panel Admin Settings85
Unit Time87
Front Panel Alarms/Logs88
Figure 82: Alarm Descriptions89
Conditions90
Figure 83: Relay Event Descriptions91
Events92
SNMP Trap Configurations93
Licenses94
Appendix95
Open Source Software102
Warranty103
Support and Contact Information104

Sencore SMD 989 - SNMP Trap Managers

Table of Contents

Related product manuals