Sencore SMD 989 - Conditions

SMD 989– User Manual
Page 90 (105)
CONDITION SELECT
↕

>FAN ERROR - UNIT
3V SUPPLY ERROR - UNIT
5V SUPPLY ERROR - UNIT
12V SUPPLY ERROR – UNIT
ASI TS SYNC ERROR – BAY 1
FAN ERROR
↕

>LOGGING: ENABLED
SNMP TRAP: DISABLED
RELAY: RELAY 1
RELAY ACTIVATION: DISABLED
ALARM NOTIFICATION: ENABLED
sensor3VMinLimit.0 - 3.10 VDC
sensor3VMaxLimit.0 - 3.50 VDC
5 Volt Controller Supply
sensor5VMinLimit.0 - 4.70 VDC
sensor5VMaxLimit.0 - 5.30 VDC
12 Volt Controller Supply
sensor12VMinLimit.0 - 11.28 VDC
sensor12VMaxLimit.0 - 12.72 VDC
Unit Temperature
sensorTempMinLimit.0 - 0 C
sensorTempMaxLimit.0 - 45.00 C
Conditions
Each condition can be user configurable to be an
error, logged, SNMP trap, and alarm relay triggered
event.