Sendai CD988BT - Menu Function

11
TA VOL
Rotate the knob to adjust TA volume.
RETUNE mode
RETUNE mode: Rotate the knob to choose
RETUNE-S or RETUNE-L.
RETUNE-S or RETUNE-L is time length
selection of TA SEEK retune interval.
RETUNE-S:short,TASEEKretuneintervalis
45 seconds.
RETUNE-L:long,TASEEKretuneintervalis
180 seconds.
Remark: RETUNE mode functions for TA
during TA SEEK mode only.
DSP mode
Rotate the knob to choose DSP sound effect:
POP - ROCK - CLASSIC - FLAT - DSP OFF
LOCAL/DX mode
Rotate the knob to choose tuner sensitivity
local or distant.
BEEP ON/OFF mode
Rotate the knob to choose button beep sound
on or off.
STEREO/MONO mode
Rotate the knob to choose FM stereo or mono.
VOL LAST/ADJUST mode
Press MENU button to choose VOL LAST,
the turn-on volume level is the volume level of
latest power off.
RotateknobtochooseVOLADJ,thenrotate
the knob to set the turn-on volume level.
WOOF ON/OFF mode
Rotate the knob to choose Sub-woofer on or
off.
LOUD mode
Rotate the knob to choose loudness on or off.
SEEK 1 / 2 mode
SEEK 1: Searching station will stop when the
next station is received.
SEEK 2: Searching station will stop when
or button is released and next station is
received.
12/24 HOUR SET mode
Press MENU button to enter 12/24 hour set
mode,rotatetheknobtoselect12or24hour
mode.
Press the MENU button more than 2 seconds
toentermenumode,theneachpresschanges
themode,rotatetheVOLknobtoadjust.
TA mode
Rotate the knob to choose TA ALARM or TA
SEEK mode.
IftheTA (trafcAnnouncements)isturnedon
and there is no traffic program identification
codereceived inthe specifiedtime,noTA/
TP will display and either TA ALARM or TA
SEEK will be activated.
TA ALARM mode : Alarm is turned on.
TA SEEK mode: TA SEEK is automatically
activated.
MASK mode
Rotate the knob to choose MASK DPI or
MASK ALL mode.
In some cases, the AF function may be
influenced bysome interference, examples
are signals with strong field but without the
RDS data.Forthisreason,the unit has two
options to avoid the above interference.
MASK DPI mode :
Only AF which h a s d i f f e r e n t p r ogram
identicationismasked.
MASK ALL mode :
T h e A F wh i c h ha s d if f e r e n t p r og r a m
identification and NO RDS signal with high
eldstrengthismasked.
Menu Function