Sendai CD988BT - Specifications

15
Specications
General
Powersupply: 12VDC( 11V-16V)
  Testvoltage14.4V,negativeground
Maximum power output: 45Wx4 channels
Suitable speaker impedance: 4-8 ohm
Suitable speaker power: 80-100 Wx4 channels
Pre-Amp output voltage: 2.0V(CDplaymode:1KHz,0dB,10K load)
Fuse: 15A
Weight: 1.64kg
Dimensions(WxHxD): 178x50x166mm
Sub-out(optional): 2.0V
Aux-in(optional):  300mV
FM Stereo Radio
Frequencyrange: 87.5-108.0MHz(EUR)
  87.5-107.9MHz(USA)
Usable sensitivity: 10dBμ
Frequencyresponse: 30Hz-15kHz
Stereoseparation: 30dB(1kHz )
Image response ratio: 50dB
IF response ratio: 70dB
Signal/noise ratio: 55dB
AM(MW) Radio
Frequencyrange: 522-1620KHz(EUR)
  530-1710KHz(USA)
Usablesensitivity(S/N=20dB): 30dBμ
Note:Specicationsandthedesignaresubjecttochangewithoutnotice
due to improvements in technology.
Disc Player
System: Disc digital audio system
Frequencyresponse: 20Hz-20kHz
Signal/noise ratio: >75dB
Totalharmonicdistortion: Lessthan0.20%(1KHz)
Channel separation: >60dB
ESP mode: CD
12s,MP3 90s
Components
Mounting collar 1
Machine screws M5x6 mm 4
Mountingbolt(50mm) 1
Wire connector 1
Case for removable control panel 1
Trim plate 1
T-key 2
Rubber cushion 1
Remote Control 1
External microphone 1