Sendai CD988BT - General Operation; Power and Volume Control; Source Selection; Display and Clock Setting

5
General Operation
Power On/Off Button
Press the PWR button to turn the unit on when
the vehicle ignition switch is on. Long press to
turn the unit off.
Adjust Volume level
Rotate the VOL knob to adjust volume
level. Rotate it clockwise to increase and
anticlockwise to decrease the volume.
Mode Button (SRC)
Press the SRC button to change between
Radio, DISC (when disc is in), USB(when
USB connected), SD/MMC card(when card
inserted),AUXplayorBTaudio.
Disc Load/Eject
Load: Press toipdownthepanel.Insert
the disc into the slot .
Eject: Press toipdownthepanel.Press
to eject the disc .
Auxiliary Input (optional)
To access an auxiliary device:
1. Connect the portable audio player to the
AUX interface.
2. Press the SRC button to select Aux-In
mode.
3. Press SRC again to cancel Aux-In mode
and go to the next mode.
Display Selector (DISP)
This unit can display either the clock time
or radio frequency/CD player functions.
Ord i nari ly, t he r a dio f requ e ncy o r CD
player track indication isdisplayed, butthe
unit will display the time when the DISP
button is pressed. The time will display for
approximately 5 seconds then return to the
radio or CD player function display.
Setting the Clock
The correct time of day can be set by pressing
and holding the DISP button.
Tosettheclock,performthefollowingsteps:
1. Turn the vehicle ignition and radio on.
2. Press the DISP button to view the clock.
3. Withtheclockvisibleonthedisplay,press
and hold the DISP button until the time
displayashes.
4. Within 5 seconds, rotate the VOLknob
counter clockwise to adjust the minutes to
thedesired setting. Tochangethehour,
rotate the VOL knob clockwise to adjust
the hour to the desired time.
5. Press DISP button to confirm and exit
clock setting.
Radio Operation
Band Switch
Press BAND button to select radio band as
follows:FM1,FM2,FM3,AM1,AM2
TUNE
MANU SEEK: Press or to tune step by
step.
AUTO SEEK: Press or more than 2
seconds to seek automatically.
Store Station Manually
Press button 1 - 6 more than 2 seconds to
store current station.
Press1-6brieytorecallpresetstation.
Store Station Automatically
Press AMS button more than 2 seconds to
seek and save the 10 strongest stations in
current band automatically.
Press AMS button briefly to intro play the
preset stations.