Selects the number of writing attempts to be made on a serial slave before returning an error.
PORT #1 MAX READ NUM
Sets the maximum number of simultaneous serial reading ModBUS registers, the firmware will use this value to
optimize the ModBUS readings.
PORT #1 MAX WRITE NUM
Sets the maximum number of simultaneous writing ModBUS registers of the serial, the firmware will use this
value to optimize the ModBUS writings.
PORT #2 BAUDRATE (default: 38400 baud) (only for Z-KEY-I and Z-KEY-2ETH-I)
Selects the communication speed of the COM #2 serial port
PORT #2 DATA BITS (default: 38400 baud) (only for Z-KEY-I and Z-KEY-2ETH-I)
Selects the communication speed of the COM #2 serial port
PORT #2 PARITY (default: None) (only for Z-KEY-I and Z-KEY-2ETH-I)
Sets the parity for the COM #2 serial communication port.
PORT #2 STOP BIT (default: 1) (only for Z-KEY-I and Z-KEY-2ETH-I)
Sets the number of stop bits for the COM #2 serial communication port.
PORT# 2 TIMEOUT [ms] (only for Z-KEY-I and Z-KEY-2ETH-I)
Sets the wait time before defining fail.
PORT #2 WRITING RETRIES (default: 3) (only for Z-KEY-I and Z-KEY-2ETH-I)
Selects the number of writing attempts to be made on a serial slave before returning an error.
PORT #2 MAX READ NUM (only for Z-KEY-I and Z-KEY-2ETH-I)
Sets the maximum number of simultaneous reading ModBUS registers of the remote TCP-IP Modbus server,
the firmware will use this value to optimize the ModBUS readings.
PORT #2 MAX WRITE NUM (only for Z-KEY-I and Z-KEY-2ETH-I)
Sets the maximum number of simultaneous writing ModBUS registers of the serial, the firmware will use this
value to optimize the ModBUS writings.
WEB SERVER AUTHENTICATION USER NAME (default: admin)
Sets the username to access the webserver.
WEB SERVER PASSWORD (default: admin)
Sets the password to access the webserver and to read/write the configuration (if enabled).
To Next Page
Loading...
