Seneca R-KEY-LT - Debug LEDs Status; Default Configuration Settings

User Manual
R-KEY-LT
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
www.seneca.it
Doc. MI004870-EN
Rev. 1.0.0.0
Page 10
DEBUG LEDS
LED
STATE
MEANING
PWR
OFF
R-KEY-LT is switched off
PWR
FLASHING
R-KEY-LT is waiting an ip address from the DHCP server
PWR
ON
R-KEY-LT has acquired an IP address
RX
FLASHING
Data reception on serial port
TX
FLASHING
Data transmission on serial port
DEFAULT CONFIGURATION
The default configuration is:
IP: DHCP mode
Mode: Modbus Ethernet to Modbus RTU
Serial: Baud rate 38400,8bit ,No parity,1 stop bit