Seneca R-KEY-LT - DIP Switch Settings; Web Server Configuration

User Manual
R-KEY-LT
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
www.seneca.it
Doc. MI004870-EN
Rev. 1.0.0.0
Page 16
5.4. DIP SWITCHES SW1 AND SW2 CONFIGURATION
WARNING!
Dip switches configuration are active only after a reboot!
For reboot the device you can power off/on the power supply or press the “Reset” button until all leds
are ON (about 5 seconds).
SW1 ACTION
SW1 DIP1
SW1 DIP2
RS485 BUS POLARIZER ON
ON
ON
RS485 BUS POLARIZER OFF
OFF
OFF
SW2 ACTION
SW2 DIP1
SW2 DIP2
USE CONFIGURATION FROM FLASH
(DEFAULT)
OFF
OFF
WRITE AND USE FACTORY DEFAULT
CONFIGURATION (WITH DHCP ON)
ON
ON
FORCE IP TO 192.168.90.101
OFF
ON
RESERVED
ON
OFF
5.5. WEB SERVER CONFIGURATION
For access to the internal webserver type in a browser the R-KEY-LT ip address, for example:
http://192.168.90.101
then enter the username and password (default: user name = admin, password = admin).
The first page is the “Status” page: