Product overview
Flex 5000 | 9
Overview of the Receiver status LED
Overview of the Transmitter status LED
Overview of the acoustic signals/beeps
Receiver status
LED The receiver...
– ... is switched off.
lights up green
... is connected to the transmitter.
lights up red
... is connected to the transmitter, the
rechargeable battery is almost empty.
flashes green
... is not connected to the transmitter or
cannot connect to the transmitter.
flashes red
... is not connected to the transmitter or
cannot connect to the transmitter, the
rechargeable battery is almost empty.
1s1s
1s1s
Transmitter status
LED
The transmitter...
– ... is in standby mode.
lights up white
... and the stethoset receiver are
connected. The speech intelligibility
function is deactivated (see page 25).
lights up blue
... and the stethoset receiver are
connected. The speech intelligibility
function is activated (see page 25).
flashes blue and white
... has detected an incompatible digital
audio signal (see page 12).
The LEDs on the receiver and on the transmitter indicate the
current operating state. If you are not pressing any button on
the receiver, the LEDs automatically dim after approx. 30 sec-
onds to not disturb you.
Beeps... Meaning
during operation,
2 beeps
The rechargeable battery is almost
empty, recharge it (see page 16).
during operation, no audio
transmission, 5 beeps
The receiver is outside the
transmission range (see page 35).
when changing the volume The maximum or minimum volume is
reached (see page 21).
when changing the balance
setting
The maximum or minimum balance
setting is reached (see page 22).
To Next Page
Loading...
