Sennheiser Set 830 S - Putting the Set 830 S into Operation; Setting up the Transmitter

6
Putting the Set 830 S into operation
Putting the Set 830 S into operation
Setting up the transmitter
왘 Place the transmitter so that:
– there are no obstacles in the light path between trans-
mitter and receiver and
– transmitter and receiver are not exposed to direct
sunlight. Direct sunlight may interfere with the recep-
tion and may damage the transmitter.
If you are using a plasma TV screen:
Plasma TV screens radiate an infra-red signal that can
adversely affect the transmission quality.
왘 Make sure that the transmitter is placed as far as
possible from your plasma TV screen.
왘 If necessary, use a standard extension cable (3.5 mm
stereo jack plug) to reduce the distance between trans-
mitter and receiver. This extension cable is available from
your Sennheiser dealer.
Note:
One transmitter can be used to transmit to several
receivers on the same frequency.