Using the Set 880
Set 880 | 19
Using the Set 880
Switching the wireless headphone system on
1 Switch your audio source on.
If the transmitter is connected to the headphone socket
(see page 12) of your TV/audio source, adjust the volume of
the headphone socket on your TV/audio source to at least
a medium level.
2 Take the stethoset receiver out of the transmitter’s
charging compartment and pull the ear bows apart so that
you can put the receiver on.
The stethoset receiver automatically switches on when you
pull the ear bows apart. The transmitter automatically
switches on and the
Transmitter status
LED lights up white
or blue.
3 If necessary, select the desired audio source by pressing
the
Audio source
button for 2 seconds (see page
21).
The audio transmission starts.
The remaining operating time of the stethoset receiver is
displayed on the transmitter (see page 16).
WARNING
Danger due to high volume levels!
This receiver allows you to set higher volumes than conven-
tional devices. Constant high-volume use can cause hearing
damage.
b Before putting the stethoset receiver on, set the volume on
the receiver to a low level.
b Do not expose yourself to high volume levels for extended
periods of time.
b Use a hearing profile (see page 25) that improves especially
speech intelligibility without the need for a high volume.
To Next Page
Loading...
