Sennheiser Set 880 - Cleaning and maintaining the Set 880

Cleaning and maintaining the Set 880
30 | Set 880
Cleaning and maintaining the
Set
880
To clean the wireless headphone system:
b Switch your wireless headphone system off and disconnect
the transmitter from the wall socket before cleaning.
b Clean the product only with a soft, dry cloth.
b Clean the charging contacts on the stethoset receiver and
in the charging compartment from time to time using e.g. a
cotton swab.
To clean the ear pads:
b Reach behind the ear pads with your fingernails so that you
can carefully detach the ear pads from the stethoset
receiver.
b Clean the ear pads under lukewarm running water.
b Let the ear pads air dry at room temperature for at least 12
hours before using them again.
b Put the ear pads back on the stethoset receiver.
The rubber ring of the ear pads locks into place on the ste-
thoset receiver.
CAUTION
Liquids can damage the electronics of the product!
Liquids entering the housing of the product can cause a short-
circuit and damage the electronics.
b Keep all liquids far away from the product.
b Do not use any solvents or cleansing agents.