Important information about your
Gluco Spark blood glucose monitoring system
Important:
The Gluco Spark meter should only be used with Gluco Spark test strips. Using other
test strips with this meter can produce inaccurate results.
Warning:
The Gluco Spark system contains small parts that may be dangerous if swallowed.
Caution:
Please read all the instructions provided in this owner 's booklet and practice the
testing procedures before using the Gluco Spark system. Blood glucose monitoring
should be done with the guidance of a healthcare professional.
The Gluco Spark system is intended for use outside the body (in other
words, in vitro diagnostic use only).
The Gluco Spark system is used for measuring blood glucose (also known
as blood sugar) from samples taken from the forearm, upper arm, hand,
thigh, calf or fingers.
Do use the Gluco Spark system for:
Testing blood glucose.
Testing only with fresh capillary whole blood samples.
Important health-related information
Severe dehydration and excessive water loss may cause false low results.
If you believe you are suffering from severe dehydration, consult your
physician or doctor immediately.
Test results below 70 mg/dL mean low blood glucose (hypoglycemia).
Test results greater than 180 mg/dL mean high blood glucose
(hyperglycemia).
If you get results below 70 mg/dL or above 180 mg/dL and do not have
symptoms of hypoglycemia or hyperglycemia, repeat the test. If you
have symptoms or continue to get results that fall below 70 mg/dL or
above 180 mg/dL, follow the treatment/advice of your healthcare
professional.
If you are experiencing symptoms that are not consistent with your blood
glucose test and you have followed all instructions described in the
Gluco Spark owner's booklet, consult your healthcare professional.
01
To Next Page
Loading...