Sensa Core Gluco Spark - Obtain a Blood Sample; Fill Test Strip with Blood

The Gluco Spark Test Strip acts like a sponge
and pulls the blood into the strip through the
sample area.
Select a test site. There are differences in testing on fingers versus other
alternative sites. Use your lancing device to obtain a blood sample.
Refer to the detailed instructions on how to use the Gluco Spark
lancing device. ( Page 9 to 11 )
Obtain a blood sample
2
3 Filling the Gluco Spark test strip with blood
Bring the Gluco Spark Test Strip to the blood
sample at a slight angle.
Do not press the Gluco Spark test strip against the test site.
Do not scrape the blood onto the Gluco Spark test strip.
Do not apply blood to the top side of the Gluco Spark test strip.
Do not apply blood to the Gluco Spark test strip when the Gluco Spark
test strip is out of the meter.
Do not put blood or foreign objects into the Gluco Spark test strip port.
Note
We recommend that you test on your fingers for better results.
Make sure that the Gluco Spark Test Strip is i n
the meter and the meter is powered on.
(If the meter is off, take out the test strip and
reinsert it into the meter.) You are now ready
to apply the blood sample.
a.
b.
c.
07