Chapter 6: Acknowledgment, Status Report & Remote Access
91
“Listen to the sound for 10 seconds.” In this case, the
PROGRAMMED,ISTENIN4IMEISSETATSECONDS4HISFEATUREIS
NOTAVAILABLEWHENOBTAININGTHE3TATUS2EPORTONSITEDIRECTLYAT
THEKEYPAD
4HE3TATUS2EPORTREPEATSONCEMOREANDTHE-ODEL
concludes the call, saying: “Goodbye.”4HE3TATUS2EPORTWILL
not repeat if obtained at the keypad; “Goodbye,” is also not
RECITED
4HEPHRASE “no number”ATTHEENDOFA3TATUS2EPORTINDICATES
THATNODIALOUTPHONENUMBERSHAVEBEENPROGRAMMED
([DPSOH6WDWXV5HSRUW([LVWLQJ$ODUPV
:ONESANDARECONFIGUREDASDRYCONTACTAND
zone 1 is configured as temperature. An emergency situation is
at hand: a fire in a greenhouse has tripped a smoke alarm and
electrical power has been disrupted. In addition to high sound and
!#POWERALARMSSEPARATEALARMSEXISTONZONESAND
9OUHAPPENTOCALLINFORTHE3TATUS2EPORTWHICHBEGINSWITH
Hello, this is 555-1234; “this is the Sensaphone 800 at ACME
Greenhouse, 225 Oak Street”
It is now 8:45 PM
Zone 1, “Temperature in greenhouse”, 110 degrees Fahrenheit,
too high, acknowledged alarm exists
Zone 2, “Door alarm in greenhouse”, not OK, acknowledged
alarm exists
Zone 3 “Water pressure alarm in greenhouse”, not OK,
acknowledged alarm exists
Zone 4 “Greenhouse control system”, not OK, acknowledged
alarm exists
Zone 5 “Emergency generator alarm”, not OK, acknowledged
alarm exists
Zone 6, OK
Zone 7, OK
Zone 8, OK
A High Sound alarm exists, it is now too high
The Power is Off.
The Batteries are Low.