Sensaphone 800 - Page 93

Sensaphone
®
Model 800 User’s Manual
92
The Output is Off.
Listen to the sound for 10 seconds.
Goodbye.
([DPSOH6WDWXV5HSRUW'LVDEOHG=RQHV
)FAZONEISDISABLEDTHEDIALOUTFEATUREFORTHATZONEIS
deactivated, but all other programmed parameters remain in
EFFECT)NTHEEXAMPLEBELOWALLZONESAREDISABLEDALTHOUGH
zones 1 and 3 are detecting alarms. AC power and Sound Level
AREALSODISABLEDFORDIALOUT7HENYOUCALLTHE-ODELFORA
3TATUS2EPORTYOUHEARTHEFOLLOWING
Hello, this is 555-1234; “this is the Sensaphone 800 at ACME
Greenhouse, 225 Oak Street”
It is now 8:45 PM
Zone 1, “Temperature in greenhouse”, the alarm is disabled, it
is now 110 degrees Fahrenheit, too high, acknowledged alarm
exists.
Zone 2, “Door alarm in greenhouse”, the alarm is disabled, it is
now not OK, acknowledged alarm exists.
Zone 3 “Water pressure alarm in greenhouse”, the alarm is
disabled, it is not OK.
Zone 4 “Greenhouse control system”, the alarm is disabled, it is
not OK.
Zone 5 “Emergency generator alarm”, the alarm is disabled, it is
not OK.
Zone 6, the alarm is disabled, it is now OK
Zone 7, the alarm is disabled, it is now OK
Zone 8, the alarm is disabled, it is now OK
The Sound alarm is disabled, it is now too high
The Power alarm is disabled, it is now Off.
The Batteries are Low.
The Output is On.
Listen to the sound for 10 seconds.
Goodbye.
4HE3TATUS2EPORTREPEATSONCEMOREANDTHE-ODEL
concludes the call, saying: “Goodbye.”