senseFly eBee X - Getting the eBee X Ready to Fly; General Airframe Inspection

Using your eBee X
10 Getting the eBee X ready to fly
The eBee X’s simple design means it can go from the box to being ready for flight
in minutes. We recommend that you perform the following steps before every
flight to ensure that the platform is best prepared for flight.
Note: Remove the warning sticker from the motor before your first
flight.
Caution: Do not perform the inspection, propeller, camera or wing
installation with the battery connected to the drone.
6
2
4
Wing - detachedCentral body: top Central body: bottom
5
10.1 Step 1: Perform a general inspection
Visually inspect the drone for damage or wear using the following steps:
1. Check the central body and wings for cracks or other damage.
2. Verify that the pitot probe is properly attached to the airframe and that the
34