Using your eBee X
Note: If there was any problem during the pre-flight checks per-
formed by the drone this will reported in eMotion and the drone’s sta-
tus LED blinking red. See your eMotion User Manual for a description
of possible pre-flight errors and how to handle them.
10.6 Step 6: Connect to eMotion
Start byconnecting the USB groundmodemtoyourcomputer. Then launch eMotion
and follow the instructions in your eMotion user manual to connect your drone to
eMotion.
Note: Each eBee X is paired with the ground modem it is delivered
with, and will only work with that modem.
Note: Do not use a USB cable that is more than 3 m (10 ft) long.
When a connection is established eMotion’s Status Panel will indicate the current
state of the drone. While the eBee X obtains its location the Status Panel will in-
dicate ‘GNSS: Waiting for signals...’. During this time the status LED on the drone
will pulse blue.
Once your drone has set its position using GNSS signals, an icon of the drone will
appear at its location on the map. If the drone’s location is not on the map you can
centre the map on the drone³. The drone’s status on eMotion will be displayed as
Idle and its status LED will shine solid blue.
You can now set take-off and landing spots, assign a mission plan and fly your
drone. See your eMotion user manual for details.
³ see your eMotion user manual
44
To Next Page
Loading...
