Flying the eBee X
11.14 Cleaning the eBee X
Use a damp cloth to wipe off dirt from the eBee X’ sensor modules, wings, body,
motors and propellers.
Use the cloth, cleaning fluid and cleaning tool provided to clean the camera lense
and ground sensor.
Caution: Never bring the eBee X into direct contact with water; this
may damage its electronics.
11.15 Storing the eBee X
Always clean the
eBee X
before returning it to its case for storage.
Whenever possible, store the eBee X in the case it was supplied in.
If you must store the drone outside its case, to avoid wing deformation, store it on
a flat surface at room temperature.
Do not store the drone near a heat source, in direct sunlight or in a hot place.
Caution: As with most electronic equipment, to avoid a malfunction
due to condensation forming inside the drone, avoid powering it on
immediately after moving it from a cold to a warm environment.
11.16 Replacing the rubber bands and propeller
11.16.1 Rubber bands
A rubber band in good condition has no cracks in it. If cracks appear, replace the
rubber bands with new ones. Always replace all three rubber bands.
We recommend regularly removing the rubber bands and inspecting them for
cracks. It is especially important to inspect the part of the rubber band that passes
under the propeller mount. This is an area where the rubber band experiences
83
To Next Page
Loading...
