Maintenance and repair of the eBee X
• The charger may become hot during use. Take care when handling it.
• If the battery or the charger behaves unexpectedly during charging (for
example, overheating, smoking, melting, leaking, etc) immediately discon-
nect the mains and store the battery and charger in a safe location.
• Keep the charger away from dust, moisture, rain, heat sources, direct sun-
light and vibration. Never drop the charger.
• Only power the charger with the specified operating voltages.
• Place the charger and battery on a heat-resistant, non-flammable, non-
conductive surface. Never place them on an upholstered surface such as
a car seat or carpet.
• Keepall inflammable liquids and materialsawayfrom the battery and charger.
If the charger detects a charging voltage outside of the allowable range it will
sound an alarm. Carry out the following procedure:
1. Check that the charging cable is properly connected with the correct po-
larity.
2. Check that the balancing cable is properly connected. If it is not, unplug
the charger from the mains, reconnect the balancing cable then plug the
charger back in.
3. If the alarm continuestosound,the battery has developed a fault and should
be discarded.
Caution: The batteries delivered with your drone are designed to
be charged only with approved senseFly chargers. senseFly cannot
be held responsible for any consequences resulting from using any
other charger. In particular, using a charger improperly configured
or designed for other types of batteries may lead the battery to be
permanently damaged or to catch fire.
86
To Next Page
Loading...
