MT4412E Rev.3 15/10/2019 Page 23 of 30
2.6) TCP/IP optional module
Via an optional interface, to be connected to the RS232 port, it is possible to connect the
central unit on a LAN/WAN network with TCP/IP protocol. The following features are
available with this type of connection:
• Remote modification of the central unit settings by the programming software
• Remote management of the central unit, via third party software, by using the
ModBus protocol
• Remote management of the central unit, via a monitoring software made by
Sensitron (available in the future)
For technical features and use of TCP/IP module, please consult the product
documentation.
3) SYSTEM POWER UP AND OPERATION
The chapter explains the procedures for the operation, powering on and maintenance of
the Multiscan 8+ central unit
The Multiscan 8+ central unit can only be programmed by means of a personal computer with the
appropriate software.
Fig. 3) Front panel of the central unit
To Next Page
Loading...