SENTRY II 930TA Series - Setting the Time of Day

20
0.0
2890
Screen 3
5:20
The time of day should only need to be set after initial installation or after an extended power outage. If an
extended power outage has occurred, the time of day will flash indicating that it needs to be set.
SET
CLOCK
NEXT REGEN
Set the Time of Day
Step 1 - Press SET CLOCK
Step 2 - Current Time of Day - Hours: Adjust to the correct hour by pressing the UP or
DOWN arrow button. Press NEXT to go to Step 3.
Step 3 - Current Time of Day - Minutes: Adjust to the correct minutes by pressing the up or
down arrow button. Press NEXT to return to the normal operating screen.
SET
CLOCK
NEXT REGEN
SET TIME
4:35
PM
SET
CLOCK
NEXT REGEN
SET TIME
5:20
PM
Exit
Programming
Mode
Step 1
Step 2
Step 3
Control Valve Programming
During normal operation one of three screens can be displayed.
Pressing the NEXT button alternates between these screens.
SET
CLOCK
NEXT REGEN
Normal Operating Screens
Screen 1 - Current Time of Day
Screen 2 - Current Flow Rate in Gallons per Minute and A/B Tank Indicator (Lower case b)
Note:
Screen 3 - Capacity Remaining in Gallons
A
SET
CLOCK
NEXT REGEN
GAL
MIN
SET
CLOCK
NEXT REGEN
CAPACITY REMAINING
GAL
Screen 1
Screen 2
TIME
PM