Seppi MULTIFORST - Starting Cooling System; Start-up and Processing

17
16
DEUTSCHESPAÑOL ITALIANO ENGLISHFRANCIS
Before starting to work with
the stone crusher, inspect its
designated work area.
- Lift the machine a few cm so that the rotor does
not touch the ground
- Take care to correctly angle the PTO shaft ac-
cording to the indications in chapter 4.2.3
- Start the tractor PTO at moderate speed,
selecting the speed prescribed for the mulcher
(540 or 1000 rpm). In case of hydraulically driven
machine, feed the pump/s.
- Increase engine speed to gradually reach the
nominal rpm (540 or 1000 rpm)
- Lower the machine to the desired depth by acting
on the tractor lift or on the position of the com-
pacting roller.
- Advance by pulling the machine (normally in
forward gear) to till the soil and to crush the
- Turn off the main switch when work is over to
avoid discharging the battery.
- Connect the system following the instructions in
point 4.2.5.
- Turn on the main switch. The switch lights up.
- Turn on the fan switch. The switch lights up.
- Check operation of the thermometer and of the
fan.
5.3 Starting cooling system:
If the transmission temper-
ature exceeds 90°, stop the
machine and check the cooling
system. Never work without
the cooling system and tem-
perature sensor running!
The performance capacity of
the machine must NEVER be
exceeded.
5.4 Start-up and processing
min 5 cm
stones or, for forestry work, feed the crusher
with material to be mulched.
- Close the hood to improve mulching.
- Advance by pushing the machine (normally in re-
verse) to fell the trees. Open the hood and adjust
the compacting roller (4.3.2 and 4.3.4)
main power switch
rev counter
radiator on-off
switch
high-low speed
change
radiator oil
temperature
indicator
Never fell trees more than
twice as high as the forestry
tiller or stone crusher (with
or without compacting roller).
They could fall on the operator.
movement
movement