Introduction
Thank you for purchasing the ONE. At Rane, performance and reliability mean as much to us as they do to you.
That’s why we design our equipment with only one thing in mind—to make your performance the best it can be.
Box Contents
ONE
Power Cable
USB Cable
Software Download Card
User Guide
Safety & Warranty Manual
Support
For the latest information about this product (documentation, technical specifications, system requirements,
compatibility information, etc.) and product registration, visit rane.com
For additional product support, visit rane.com/support
Setup
Assemble the Platter System
1. Remove the ONE base from the packaging. Remove the platter assemblies from the package (underneath
ONE). Place ONE on a flat, stable surface for assembly and operation.
2. Place the platters onto each deck of the ONE base by aligning the pins in the bottom of the platter with the
holes in ONE’s motor. Press it down firmly. Check to make sure that it rotates uniformly and does not wobble
excessively.
3. Place the slipmat onto the platter. Then place the Control Disc over the spindle (with the attached Quick
Release Adapter on top). To lock the Control Disc to the spindle, pinch the top of the spindle while slowly
rotating the disc until you hear it click. It locks when the groove in the spindle lines up directly opposite to the
button on the side of the Quick Release Adapter.
To Next Page
Loading...
