Switched PRO2 – User Guide
Using the Web Interface • 117
To set a user’s access level:
1. For the user name displayed in the list, click the Edit link. The Local User Edit page displays.
2. From the Access Level drop-down menu, select the desired user access level as described in the table
below.
3. Click Apply.
User Access Level
(highest to lowest)
Administrative user; Full access for all configuration, all outlet power control actions
(On, Off, Reboot), status, and serial/pass-thru ports.
Full access for all outlet power control actions (On, Off, Reboot), status, and
serial/pass-thru ports.
Note: The Power User does not have access to user management.
Partial access for outlet power control actions (On, Off, Reboot), status, and pass-thru
of assigned outlets, outlet groups, and serial/pass-thru ports.
Partial access for outlet power control actions (Reboot), status, and pass-thru of
assigned outlets, outlet groups, and serial/pass-thru ports.
Partial access for outlet power control actions (On), status, and pass-thru of assigned
outlets, outlet groups, and serial/pass-thru ports.
Partial access for status and pass-thru of assigned outlets, outlet groups, and
serial/pass-thru ports.
Access to all “stat” commands on the Command Line Interface (CLI).
To change a user’s password:
1. For the user name displayed in the list, click the Edit link. The Local User Edit page displays.
2. Type the user’s new password; type a 1-32 character password; ASCII 33 to 126 decimal characters are
allowed; passwords are case-sensitive.
3. Verify the new password.
4. Click Apply.
To delete a local user:
1. For the user name displayed in the list, click the Remove link. You will be prompted with a confirmation for
the delete action.
2. Click OK or Cancel.
Note: The admn default administrator account cannot be removed unless administrative access has already
been granted to another administrative account.
To Next Page
Loading...