Server Technology switched pro2 - Page 159

Switched PRO2 – User Guide
Using the Command Line Interface (CLI) • 159
set feature
Enables new system features.
Command Syntax
set feature <feature key>
Parameters
The set feature command uses the following parameter:
feature key
Key for unlocking system features (XXXX-XXXX-XXXX-XXXX), where
X = 0-9 or A-Z.
Command Access
Admin level only
set ftp
Sets FTP configuration values.
Command Syntax
set ftp autoupdate [disabled | enabled]
set ftp autoupdate day [sunday-saturday | everyday]
set ftp autoupdate hour [1am-12am | 1pm-12pm]
set ftp directory <path name>
set ftp filename <filename>
set ftp host <hostname>
set ftp password <password>
set ftp server [disabled | enabled]
set ftp test [full]
set ftp username <username>
Parameters
The set ftp command uses the following parameters:
autoupdate
Sets to use automatic system firmware updates.
directory
Sets the directory of the update file in remote FTP update server.
0-64 characters.
filename
Sets the name of the update file in remote FTP update server.
0-32 characters.
host
Sets the hostname of remote FTP update server. 0-63 characters.
password
Sets the password for logging into the remote FTP update server.
0-32 characters.
server
Sets if the system can be an FTP server to serve system files.
test
Tests current FTP settings. Using the full sub-parameter ensures
connection to the FTP server is correct, verifies firmware can be sent to
the PDU, and downloads firmware to the PDU (but does not install
firmware).
username
Sets the username for logging into the remote FTP update server.
0-32 characters.