Server Technology switched pro2 - Page 160

Switched PRO2 – User Guide
Using the Command Line Interface (CLI) • 160
Sub-Parameters
The set ftp command uses the following sub-parameters:
day
Sets the day of the week to automatically update system firmware.
hour
Sets the hour of the day to automatically update system firmware.
Command Access
Admin level only; no access in Demo mode
set http
Sets HTTP configuration values.
Command Syntax
set http [disabled | enabled]
set http port <port>
Parameters
The set http command uses the following parameter:
port
Sets the port for HTTP connections. 1-65535 (default 443).
Command Access
Admin level only; no access in Demo mode
set https
Sets HTTPS configuration values.
Command Syntax
set https [disabled | enabled]
set https port <port>
set https usercert [disabled | enabled]
set https userpass <passphrase>
Parameters
The set https command uses the following parameters:
port
Sets the port for HTTPS connections.1-65535 (default 80).
usercert
Sets to use user-provided certificates instead of system self-signed
certificates.
userpass
Sets the pass phrase for user-provided certificates. 0-63 characters.
Command Access
Admin level only; no access in Demo mode